Ask Me Solution

Stop Code: STOP 0×0000000A
IRQL_NOT_LESS_EQUAL

Code Meaning :
Faulty device drivers, or services from backup utilities or virus scanners
Recommended Resolution:
Remove, disable or stop the offending drivers, backup utilities or anti-virus programs. Get updated software from the manufacturer.

Stop Code: STOP 0×0000001E
KMODE_EXCEPTION_NOT_HANDLED

Code Meaning:
Some driver files may be causing a problem.
Recommended Resolution:
Remove, disable or update the driverfile listed in the error message. Verify if new hardware installation
is correct.

Stop Code: STOP 0×00000024
NTFS_FILE_SYSTEM

Code Meaning:
Usually caused by disk corruption in the NTFS file system or third-party disk defragmenters.

Recommended Resolution:
Use hard disk diagnostic software to verify that the hard disk is working. Remember to always Use
Microsoft-certified disk defragmenters.

Stop Code: STOP 0×0000002E
DATA_BUS_ERROR

Code Meaning:
Caused by a parity error in the system memory. Almost always caused by hardware problems—a configuration issue, defective hardware, or incompatible hardware.

Recommended Resolution:
If physical RAM was recently added to the system, remove it and see if the error still occurs. If the error persists, try disabling memory caching in the BIOS. Else remove, repair or reinstall the defective hardware.

Stop Code: STOP 0×00000050
PAGE_FAULT_IN_NONPAGED_AREA

Code Meaning :
Caused when requested data is not found in memory; the system checks the page file, but the missing data is identified as unable to be written to the page file

Recommended Resolution:
Remove any newly-added hardware or run diagnostic software supplied by the manufacturer to check if
the component has failed. Install updated device drivers or roll back to a previous driver.